Onmifill System 35 Troubleshooting Guide
Issue 1- INCOMPLETE OR VERY SLOW PUMPING
- TURN THE KNOBS SHOWN IN THE IMAGE BELOW COUNTER- CLOCKWISE UNTIL THEY COME COMPLETELY OUT.
- CHECK TO MAKE SURE THE O-RINGS ON EACH OF THE KNOBS ARE IN GOOD CONDITION. IF THEY ARE TORN OR WORN DOWN PLEASE CONTACT US FOR NEW ONES.
- THREAD THE KNOBS BACK IN BY ROTATING THEM BY HAND CLOCKWISE UNTIL THEY STOP, THEN BACK EACH ONE OFF SEVERAL TURNS.
Issue 2 - NOT PUMPING AT ALL
If the machine is barely pumping or not pumping at all, then the safety valve will need adjusting.
- Insert a can and raise the platform